Water stood on the cavity floor after every run. He cleared a blocked drain path and reseated a gasket that was riding high on the seal, then ran a whole cycle through with me watching. Dry every time since.
Winifred M.2026-07-03
Pricing
What it costs
One flat visit fee, one written estimate, no charge per fault. Credited toward the repair when you approve the work. One fee per visit, not per appliance fault.
- Diagnostic
- $80
- Labor
- 90 days
- Parts
- 365 days
What does the first visit cost?
$80 flat diagnostic. Credited toward the repair when you approve the work. One fee per visit, not per appliance fault.
You get a written estimate before any part is ordered or any labor is billed.
What is covered afterwards?
90 days on labor, 365 days on parts. Genuine OEM parts only. No aftermarket substitutes on sealed gas, ignition or control components.
When can a visit be booked?
| Monday – Friday | 8:00am – 6:00pm |
|---|---|
| Saturday | 9:00am – 4:00pm |
| Sunday | Closed |
Scheduled appointments only. No after-hours or emergency service.
Common questions
- What does the first visit cost?
- A flat $80 diagnostic. It covers the trip, the testing and a written estimate, and it is credited toward the repair when you approve the work. One fee per visit, not one per fault, so a range with a dead igniter and a drifting oven thermostat is still a single charge.
- Do you charge by the hour or by the job?
- By the job. There is a flat $80 diagnostic for the visit and the full test sequence, and after that the repair is quoted as a finished figure covering the part and the labor to fit it. No hourly meter runs while a panel is off, and nothing is billed for the time a diagnosis takes to think about.
- What makes one quote higher than another on the same appliance?
- Which component is actually at fault, first and mostly. After that: whether the part rides on the van or has to be ordered, whether there is one fault or two behind the same complaint, and whether something upstream caused it. The published band table shows the spread those four things move within.
- How do you decide whether an appliance is worth repairing?
- By setting the repair band against what the same equipment costs new, which is done on one page here rather than argued on the phone. On built-in cooking equipment the repair almost always wins; what changes the answer is a discontinued part or an opening no current model fits, not the age of the unit.
- What is covered after the repair?
- 90 days on labor and 365 days on parts. Genuine OEM parts only — no aftermarket substitutes on sealed gas, ignition or control components. If the same fault returns inside the labor window, the return visit is not billed.
What it costs
What does the repair itself cost?
The whole book, on one page. A band covers parts and labor for a finished repair on this equipment; the diagnostic below is what it costs to find out which band a fault belongs in, and it comes off the bill when the work is approved.
$80 Flat $80 diagnostic covering the visit and the full diagnostic sequence, credited toward the repair once you approve the work.
| Repair | Parts and labor |
|---|---|
| Igniter or spark module replacement | $210–$530 |
| Burner valve or orifice service | $220–$680 |
| Oven thermostat or temperature sensor | $180–$550 |
| Convection fan or motor | $270–$710 |
| Control board or touch panel | $470–$1,100 |
| Door hinge, glass or seal | $180–$710 |
| Diagnostic visit | $80 |
Bands, not quotes. 90 days on labor, 365 days on parts. Genuine OEM parts only.
| Replacing it instead | Appliance only |
|---|---|
| Wall oven or built-in oven, the usual repair-or-replace comparison | $5,200–$10,500 |
| Dual-fuel or gas range, 36 inch and up | $8,500–$16,500 |
A repair that clears the top band is still well under the cheapest replacement in that table, and a replacement drags delivery, installation, ventilation and often cabinetry behind it. That arithmetic is why the estimate is written down before a part is ordered.
Customer feedback
Calls priced out of this same book
4.9
out of 5 across 82 customer reviews of this shop. Each one below is a single call, in the words of the person who paid for it.
The outdoor grill lit on one side and sulked on the other. He pulled the burner tubes, found a wasp nest inside one venturi, cleared both and put the air shutters back where they were supposed to sit.
Callum E.2026-08-12
The rotisserie motor hummed and would not turn. He took the spit off, found the bearing seized with grease and grit, replaced the motor and cleaned the mount so the new one is not sitting in the same mess.
Dashiell V.2026-01-14